APH techniek

All data are considered to be unbinding reference values. We accept no liability for data selection that is not confirmed in writing. Pressure data refer, if not otherwise indicated, to liquids of Group II at +20°C. 9 Blow guns/nozzles KD-BLP KD-BLP K 1.5 mm M 12 x 1.25 Nozzles for blow guns - short nozzles Suitable: Short nozzle for standard use SD-BLP M 12 x 1.25 Nozzles for blow guns - safety nozzles Suitable: Nozzle with centre hole and a lateral circular slot or. boreholes on the side. Protective screen formation against rebounding chippings. When closing the nozzle bore or. air venting takes place through the circular slot or the boreholes to the side. Material: Brass nickel-plated Advantages: The extension tubes with a nozzle are equipped with a rotating lock, thus allowing the tubes to be placed in any position. VLR 100 110 VLR 100 G 115 M 12 x 1.25 VLR 150 160 VLR 150 G 165 M 12 x 1.25 VLR 250 260 VLR 250 G 265 M 12 x 1.25 --- --- VLR 400 G 415 M 12 x 1.25 Nozzles for blow guns - extension tubes with nozzles type VLR ... G (straight) type KD-BLP type KD-BLP K type VLR ... (curved) SS-BLP M12 x 1.25 Nozzles for blow guns - protective screens Suitable: Assemble the protective shield behind the nozzle. Any chippings that rebound will be stopped. Warning: Please order nozzles separately Type LD-BLP M12 x 1.25 Nozzles for blow guns - noise protection Material: Aluminium with sintered brass insert Suitable: Low noise level of approx. 63 - 73 dB (A). Good blowing action up to 380 l/min. VD-BLP VD-BLP ALU M12 x 1.25 Nozzles for blow guns - venturi nozzles Suitable: Lateral air intake saves energy, whereby an amplification in the ratio of approx. 1::4 is achieved. For the same performance of the blower, only approx. 25% of the air is required. Is particularly suited for blowing dust and water. Nozzles for blow guns - controllable Suitable: Enables the air quantities to be matched optimally to the required working conditions. At the same time energy costs and sound levels are reduced. The POM short nozzle can be replaced by any nozzle with M 12 x 1.25 MT. RSD-BLP M 12 x 1.25 ü Coil tubes assembled with couplings from page 200 PU, PA, PTFE and PE hoses from page 192 Ball valves from page 280 Eye protection from page 591 Nozzle bore Thread male Thread male Thread male Thread male Thread male Thread male Type zinc- plated steel Type aluminium/POM Type POM Tube length Tube length Type curved Type straight For thread male Type plastic Type aluminium Type plastic Type aluminium APH Techniek BV - Wateringen - T +31 (0)174 219 200 - sales@aphtechniek.nl - www.aphtechniek.nl 525